top of page
Epobond fast 406

Epobond fast 406

For the rapid bonding of rubber and most plastics. This product is extremely fast curing, has excellent humidity resistance and offers a low unit cost on each bond.

Direction: Apply to one surface and join the two surfaces quickly and press for few seconds. Thinner layer of Super Glue gives stronger adhesion.

  • TYPICAL APPLICATIONS

    EPOBOND-FAST CX-406 is specially formulated for the

    bonding of most common plastics and rubbers, but will also

    bond other substrates. recommended for use on close-fitting

    parts and smooth, even surtaces.

  • SAFTEY MEASUREMENT

    BEFORE USE:

    Working conditions

    Personal safety

    Preferably wear gloves.

    Surface requirements

    The surface must be dry, clean and free of dust and grease.

    DURING USE:

  • DIRECTIONS FOR USE

    Bond speed is very fast so ensured that parts are properly.

    aligned before bonding.

    EPOBOND Activators may be required if there are gaps or

    porous surfaces. some plastics may require application of

    AP 50 primer.

    Ensure parts are clean, dry, and free from oil and grease.

    Product is normally hand applied from the bottle. Apply

    sparingly to one surface and press parts firmly together until

    handling strength is achieved. Generally, as little

    cyanoacrylate as possible should be used - over application.

    will result in slow cure speed and lower bond strength.

    Please contact our EPOBOND representative for further

    advice on dispensing solutions.

  • STORAGE CONDITIONS

    Store in a cool area out of direct sunlight.

    Refrigeration to 5°C gives optimum storage stability.

  • Download Manual

bottom of page